FLAT RATE SHIPPING ON ALL ORDERS!

QUESTIONS? CALL 866-331-9472

Forends and Rail Systems

Forends and Rail Systems

Grid List

Set Descending Direction

3 Item(s)

  1. ARClight Pathfinder Tavor Forend
    $199.95

    ***PLEASE NOTE THIS IS A SPECIAL RUN WITH LIMITED QUANTITIES***

    The Pathfinder is a direct replacement for the OEM polymer Tavor SAR forend, is 7 inches longer than the OEM forend, and is intended to act as heat protection against a suppressor that is mounted to the barrel. The monolithic design allows it to sleeve over any suppressor up to 1.75" in diameter, and most suppressors will have approximately one inch visible out the front of the forend. ARC LOK slots on the entire surface let you mount any combination of accessories and grip further out on the gun, including on top of the front of the forend. It is made of completely monolithic construction, with no welds or fasteners to fail.

    Material: 6061 aluminum

    Finish:  Type III milspec hardcoat black anodizing

    Weight: 13.4 ounces

    Length: ?? inches

    Designed and Manufactured 100% in the USA

    Learn More
  2. ARClight Tavor Forend
    $125.00

    Please note, the ARClight Tavor Forend fits the Tavor SAR and is not compatible with the X95.

    The ARClight Tavor Forend is a direct replacement for the standard Tavor SAR polymer forend, and features ARC LOK slots that allow for attachment of Manticore Arms ARC LOK rail segments (sold separately) or the attachment of Magpul MOE compatible accessories. The ARClight Tavor Forend weighs 2 ounces less than the OEM polymer forend, and gives more mounting options and greater strength all with less weight.

    Material: 6061 aluminum

    Finish:  Type III milspec hardcoat black anodizing

    Weight: 4.0 ounces

    Length: ?? inches

    Designed and Manufactured 100% in the USA

    Learn More
  3. ARClight XTL Tavor Forend
    $180.95

    Please note, the ARClight XTL Tavor Forend fits the Tavor SAR and is not compatible with the X95.

    ARClight XTL Tavor Forend is a direct replacement for the standard Tavor polymer forend. Even better, the ARClight XTL is 3 inches longer than the existing forend, thus allowing additional mounting space for accessories and a grip further out on the gun, including on top of the front of the forend. It is made of completely monolithic construction, with no welds or fasteners that can fail!

    The ARClight XTL not only allows for additional mounting space, but also will allow for mounting of a standard 1" flashlight on both 16.5" and 18" barreled Tavors. and will also sleeve over any suppressor 1.75" in diameter or smaller.The forend also features two integrally machined QD sling swivel pockets on each side, and slots at the rear underside for wire routing for those who wish to place their pressure or tape switches on the outside or mount it on a vertical foregrip under the forearm.

    Naked is just the forend, nothing else.

    Fully Loaded is the forend, Light Ring, and (1) 5 slot and (1) 11 slot rail segment.

    Material: 6061 aluminum

    Finish:  Type III milspec hardcoat black anodizing

    Weight: 8.1 ounces forend, 1.9 ounces light ring

    Length: 8.5 inches overall, projects 3 forward from face of upper receiver 

    100% designed and manufactured in the USA

    Learn More

Grid List

Set Descending Direction

3 Item(s)