Picatinny Carry Handle Mount

NOTE:  The Picatinny Carry Handle Mount should be installed with the rear peep sight flipped so that the small aperture is in use, and the large one is flush with the handle to the rear.  If flipped so the large aperture is in use, the carry handle will bear on the top edge of the rear sight- it will still be useable, but may require addition elevation adjustment on the sight. 

The Picatinny Carry Handle Mount allows the addition of any picatinny mount optic or accessory to the carry handle of the Ripley Rail system

A screw with large knurled knob retains the Carry Handle Mount, and a channel through the center of the mount allows the use of iron sights even when an optic or other system is mounting on the picatinny.

To install, place the rail in the carry handle channel, then thread in the screw into the underside of the rail through the hole in the carry handle.  Before fully tight, push the mount forward so the front of the screw acts as a recoil lug against the carry handle hole. Then tighten down fully by hand and installation is complete.

The Carry Handle Mount is made of anodized aluminum with a steel knurled screw knob with black oxide finish.

Please note this mount is foreign made.